High-frequency, high-frequency machine peak load characteristics occur too much power. Sheet profiles of small length, as well as grooved section parts, are conventionally stamped in units of one or two stampings in a special mold, but the flat section 3 should be sufficiently wide in this way. When manufacturing the punch and die of a special mold, it should be entered from the nominal thickness of the material. Set off to match the work appearance. In the closed position, the mold should correct the flat section of the part and eliminate the effects of free bending of the blank. The actual value of the blank thickness may be entered. The values ​​vary widely, so not all segments are being corrected.
30L Agriculture Drone,Fertilizer Drone,Gfrp Agricultural Sprayer,Fold Sprayer Drone
Xuzhou Jitian Intelligent Equipment Co. Ltd , https://www.jitianintelligent.com