Use the following methods to ensure that the installation is correct and reliable:
• Ensure that the 24 VDC sensor supply is noise-free and stable.
• The sensor cable is as short as possible.
• Use a shielded twisted pair for the sensor cable.
• Terminate the shield only on the sensor side.
• Unused channels should be shorted.
• Avoid bending the wires at an acute angle.
• Use cable ducts for wire bonding.
• Avoid placing signal lines parallel to high energy lines. If the two lines must coincide, they should intersect at the correct angle.
• Ensure that the input signal range is within the common mode voltage specified by the specification by isolating the input signal or selecting the common terminal of the external 24 V supply as the input signal reference point.
Note: The common mode voltage of the common mode voltage analog module is less than 12V, so be careful when using the 2-wire sensor. If the current is selected on the M side, the voltage of the signal and the power supply M are common. The reference point, the common mode voltage is the signal voltage, which meets the requirements; and when the acquisition point is selected on the 24V side, the common mode voltage is 24V, which exceeds 12V, and the module does not work normally.
With the improvement of people's quality of life, people's lifestyles have also become varied. Different kinds of recreational products are starting to appear in people's lives, such as electronic cigarettes. The emergence of e-cigarettes represents a part of young people's thinking and means that electronic products are beginning to show a trend towards diversity.
simply replace the pods. The Pod system uses an integrated pod rather than a tank for higher nicotine strength and provides low power traction. the Pod system is rechargeable and has a longer life and higher battery capacity than disposable electronic cigarettes.
Our company Pod system has a built-in 380mAh battery and a USB charging port on the bottom. In comparison, the Pod system has a built-in battery of only 180mAh, but the Pod system charges much faster.
Our electronic cigarettes are of rechargeable construction. The first time you use the charger to charge, it is recommended to use up the remaining power before filling up, this is to ensure the performance of the battery.
Vape Pod System Oem,Vape Pod Oem,Close Pod Oem,Thc Pod Disposable
Shenzhen MASON VAP Technology Co., Ltd. , https://www.masonvap.com