Comparison of technical and economic performance of integrated and split energy-saving lamps

One-piece

Split type

definition

Integrated energy-saving lamp: The electronic ballast is built into the plastic part of the lamp cap and integrated into the lamp tube.

Split type (commonly known as outer town flow) energy-saving lamps: consists of two parts: an independent electronic ballast and a lamp assembly.

volume

One-piece length is the same under the same specifications

Short length of the split type under the same specifications

life

The market version is 10,000 hours.
Engineering version 15,000 hours.

The market version is 10,000 hours.
Engineering version 15,000 hours.
The 20,000-hour ballast of the technology version can last for more than 40,000 hours.

Failure rate

The comparison of the failure rate refers to the failure rate caused by poor heat dissipation by considering only the lamp temperature baking ballast under the premise of the same technical quality and the use environment. It does not mean that the - style is due to quality reasons, resulting in a high failure rate.
- The body lamp temperature directly bakes the electronic ballast, and the heat dissipation is poor. Compared with the split type, the failure rate is high.
However, compared with other manufacturers' energy-saving lamps, the failure rate of Huabel energy-saving lamps is still very low. (3%<)

The lamp temperature does not bake the electronic ballast, and the heat dissipation is better. Compared with the body type, the failure rate is greatly reduced.

Late replacement cost

As with the initial investment, the investment is larger than the split type.

The ballast or lamp tube assembly can be replaced separately, and the investment is about 65% of the initial installation, and the investment is saved.

Lamp cover suitability

1. Due to the long total length, the lampshade has poor performance. For example, the 400 type floodlight cover, the integrated 120 or 85 type energy-saving lamps can not be installed.
2. Not suitable for closed or explosion-proof lampshades.

1. Due to the shortened total length, the lampshade has good applicability. For example, the type 400 floodlight cover, split type 120 or 85 energy-saving lamps can be loaded.
2. Suitable for closed or explosion-proof lampshades.

Use environment

The integrated type cannot be used in high temperature situations.

Can be used in higher temperature environments (less than 50 degrees Celsius).

Installation convenience

Same as self-ballasted mercury lamp

The split type, the electronic ballast and the lamp tube assembly are respectively equipped with special connecting lines and special plug connectors, and the installation does not require wiring, which is very simple and convenient.

Initial investment

basically the same